If you have graphics issues, such as a black (blank) screen or slow performance in Flight Simulator X, download and then install the latest drivers for your video card. More Information General troubleshooting information Install the latest drivers Use the developer console to see this in-sim or view it in the log.This article describes several known graphics-related issues that you may have when you play Microsoft Flight Simulator X. The art control atc/debug/log_spawn=1 prints log info on AI aircraft arrival & departure logic. X-Plane will then auto-generate these items, which will result in functional flows & networks, although they will also appear less polished.īy default, the X-Plane log.txt also includes information about AI spawning, flow selection and AI Taxi instructions. To debug problems with AI operations it is recommended to start with hiding all user specified flows and ATC taxi networks in the WED scenery pack. A working ATC Taxi network, either auto-generated by X-plane or specified in the scenery is required to have those AI successfully leave the runway and taxi to/from the ramp starts. It also implies the actual ramp start types and ATC taxi network details do not prevent AI operation, but only help to make it look more “plausible” once AI are present at the airport. Some airports may even have AI and ATC functionally without an ATC tower frequency defined in WED/apt.dat – if there is a (very rarely) used option to define ATC tower frequencies in an atc.dat file to accompany the scenery. Since X-Plane 10 it is actually officially ignored – so it’s not required. Note: In older documents – the “has ATC” property was noted as required for AI use. These are all conditions to make AI spawn or attempt to land at the airport. Sufficient width & length depends on the AI aircraft category as in the table below:.In this case, X-plane will auto-generate suitable flows that activate all runways under any weather condition. there is valid flow specification that meets the current weather condition and it includes a “Runway use” rule for that runway.At least one paved runway (surface = “Asphalt” or “Concrete” only) of sufficient width and length is active.This prevents ATC accidentally spawning AI inside a runway hotzone – which creates a fatal deadlock. The airport should have at least one ramp start of type “gate/tiedown” and all starts near the runway should be of type ”misc” only.See the “ Guide to Ramp Starts” for details on ramp start fields.X-Plane will not check if that ramp start is actually vacant or the right type – it rather gives ATC authority to make “emergency” decisions like parking a 747 on a Size A “Props” “Misc” ramp start, if none of the size F starts at that airport are available for some reason. ![]() The size of the largest ramp start (of any type) must be larger or equal to the actual AI aircraft attempting to spawn/land.At least one (very preferably multiple) ramp starts of sufficient size is specified:. ![]()
0 Comments
Leave a Reply. |